300+ câu trắc nghiệm Tiếng Anh Công nghệ ô tô có đáp án - Phần 5

Spark plugs are mounted inside ________

Which of the following provides passages for flow of cooling water?

For retaining compression in the cylinder, a flat piece of ___________ is placed between the cylinder head and cylinder block.

The main advantage of using aluminium alloy for cylinder head is ____________

Inter-metallic corrosion between steel studs and aluminium alloy lead to ___________

Why is the cylinder head cast as a separate piece?

____________ is a combination of fibre and cork granules that is more compressible and resilient.

Which of the following oil pan gaskets are not affected by oil and grease?

Which of the following is not the type of manifold gaskets?

____________ is attached to the bottom face of the cylinder block.

The cylinder block and upper half of the crank case are cast by _________ material.

_________ serves as a cooling and ventilation of engine lubricating oil.

A heat engine converts heat energy from fuel combustion or any other source into which type of work?

A steam engine comes under the category of ________

Which of these is a power-absorbing heat engine?

Which of these is a type of reciprocating steam engine?

A gas undergoes step 4 in the Carnot cycle. Which of these processes describes the 2nd step?

Thermal power plants operate on which of these cycles?

The efficiency of a combined cycle gas turbine (steam cooled) can range as high as ________

The torque available at the contact between the road and driving wheel is called _________

The engine produces mechanical power that is transmitted to the automobile’s wheels through a drivetrain.

The engine produces mechanical power that is transmitted to the automobile’s wheels through a drivetrain.

SUVs is a __________

Power is produced during

An SI engine is:

The two-stroke engine does not use _____

The transmission is a gear system that adjusts the ratio of engine speed to wheel speed.

The drive shaft is used to _____ the transmission output shaft to the differential input shaft.

The gear ratio also _____ fuel economy.

Engine, clutch, transmission, drive shaft, differential and driven wheels are elements of drivetrain system